12VDC Power Supply 35W 3A ACDC LED Power Supply Meanwell-APV-35-12(35W-12V)

Specifications

12VDC Power Supply 35W Single Output Switching Power Supply

#Introduction of Meanwell APV Series 35W -12/24V)
The APV is the entry-level products. All products are divided into constant voltage and constant current applications.
Most DC 12V and 24V can also be used with general light bar/light strip or advertising light box application. Moreover,other output voltage models are also available for choice and waterproof function is available for LP series .Other constant current application can be used according to the COB LED or SMD
LED specifications selected. Currently,the Driver current range can cover from 250/350/500/700/1050/1400mA to maximum operate up to 3150 mA (150W)for all kinds of indoor lighting applications.

#Specification

Specification	Meanwell Power Supply APV-35-12

#Output	DC Voltage	12V
Working Voltage	Rated Current	3A
	Current Range	0-3A
	Rated Power	36W
	RIPPLE NOISE (max. Note.2	150mVp-p
	VOLTAGE TOLERANCE Note.3	±5.0%
	LINE REGULATION	±1.0%
	LOAD REGULATION	±2.0%
	SETUP, RISE TIME Note.6	1500ms, 40ms/230VAC, 1500ms,40ms/115VAC at full load
	HOLD UP TIME (Typ.)	20ms/230VAC , 12ms/115VAC at full load

#Input	VOLTAGE RANGE Note.4	90-264VAC, 127-370VDC
	FREQUENCY RANGE	47-63Hz
	EFFICIENCY (Typ.)	83%
	AC CURRENT	0.5A/230VAC, 0.75A/115VAC
	INRUSH CURRENT(Typ.)	COLD START 45A(twidth=440us measured at 50% Ipeak) at 230VAC
	MAX. No. of PSUs on 16A CIRCUIT BREAKER.	6 units(circuit breaker of type B)/ 10 units (circuit breaker of type C)at 230VAC
	LEAKAGE CURRENT	0.25mA/ 240VAC

#Protection	Over Load	110%~160% rated output power Protection type Hiccup mode, recovers automatically after fault condition is removed
	Over Voltage	5.75~6.95V /13.8~16.2V/17.25~21V/27~32.4V Protection type: Shut down o/p voltage, re-power on to recover

#Environment	WORKING TEMP.	-30 ~ 70°C (Refer to "Derating Curve")
	WORKING HUMIDITY	20~90% RH non-condensing
	STORAGE TEMP., HUMIDITY	-40~+80℃，10~95%RH
	TEMP. COEFFICIENT	±0.03%/℃(0~50℃)
	VIBRATION	10~500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes

#Safety & EMC Standards	SAFETY STANDARDS	UL8750 ,CSA-C22.2 No.250.0-13, BIS IS15885, EAC TP TC 004,IP42,BS EN/EN 62368-1 approved
	WITHSTAND VOLTAGE	I/P-O/P: 3KVAC
	ISOLATION RESISTANCE	I/P-O/P:>100M Ohms/500VDC/25C/70% RH
	EMC EMISSION	Compliance to BS EN/EN55032,BS EN/EN61000-3-2 Class A,BS EN/EN61000-3-3, EAC TP TC 020
	EMC IMMUNITY	Compliance to BS EN/EN55035, BS EN/EN61000-4-2,3,4,5,6,8, 11; light industry level(surge 2KV), EAC TP TC 020

	MTBF	5489.6K hrs min. Telcordia SR-332(Bellcore); 600.8K hrs min. MIL-HDBK-217F(25C)
	DIMENSION	845729.5mm (LWH)
	PACKING	72pcs / 14Kg/ 0.92CUFT

Note		1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.
		2. Ripple noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf 47uf parallel capacitor.
		3. Tolerance includes set up tolerance, line regulation and load regulation.
		4. Derating may be needed under low input voltage. Please check the static characteristics for more details.
		5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
		complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
		(as available on https://www.meanwell.com/Upload/PDF/EMI_statement_en.pdf)
		6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
		7. The ambient temperature derating of 3.5°C/1000m with fanless models and of 5°C/1000m with fan models for operating altitude higher than 2000m(6500ft). 8. Products sourced from the Americas regions may not have the ENEC/BIS/CCC logo. Please contact your MEAN WELL sales for more information.
		9. For any application note and IP water proof function installation caution, please refer our user manual before using.
		https://www.meanwell.com/Upload/PDF/LED_EN.pdf
		10. This product is not intended for LED lighting luminaire applications in the EU.(In the EU the LPF/NPF/XLG series are recommended.)
		# Product Liability Disclaimer For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx